Products

  1. Top
  2. Products
  3. Dust Monitor

Dust Monitor

Dust Monitor

Electrodynamic Dust Monitor

Electrodynamic Dust Monitor

Less subject to dust adhesion on the probe comparing to tribo electric charge model or optical model.

  • Ultra high sensitivity 0.01~1000mg/m³.
  • High humidity gas is measurable with the special air purge.
  • Dust
Dynamic Opacity Dust Monitor

Dynamic Opacity Dust Monitor

Sintilation model to monitor the optical amount change and to calculate the comparison of the received optical amount and its change.

  • No influence by adhesion on the lens.
  • Applicable to big duct, boiler, furnace etc.
  • Dust
Forward Light Scatter Dust Monitor

Forward Light Scatter Dust Monitor

It uses a principle that laser light is irradiated on dust particles and the scattered light is collected, reflected, and detected via the quartz rod. It is suitable for monitoring the concentration of exhaust gases from a large boiler, kiln, etc.

  • Pin spot measurement, which receives less influence by each application.
  • Robust probe structure and anti dust adhesion efficiency.
  • Dust
Back Scatter Dust Monitor

Back Scatter Dust Monitor

No need to install 2pcs of sensors and optical axis adjustment since a sensor has both laser irradiation part and retection part in it.

  • Back scattering system to realize efficient one side installation.
  • Applicable to duct diameter 2-12m
  • Dust

© KANSAI Automation Co., LTD. All Rights Reserved.